COMMUNICATIONS between Madrid train control and the two trains involved in the horror smash in Toledo have been released.
Newly released audio recordings reveal a chain of errors at Adif’s Atocha control centre in the minutes before Wednesday’s collision between a Renfe AVE and an Iryo high-speed train near Urda, in Toledo province.
The recordings, published by El País, show that at 08:36 the controller ordered the AVE, travelling 25 kilometres behind the Iryo, to resume “normal running.”
Protocol required it to proceed on sight at no more than 40 km/h, and the controller had not first confirmed that the line ahead was clear.
READ MORE: Protesters clash with police at Madrid anti-government rally over deadly Toledo train crash

The Iryo driver received the same instruction a few minutes later.
At 08:48 she called back to report that her train was still stopped because the LZB safety system would not reset.
The two trains collided about five minutes later.
According to the government, the controller’s orders breached protocol. It is Spain’s second fatal high-speed accident in a year, on the same line, after 35 years without a single death.
The conversations in full
08:36: Atocha control centre and the AVE driver
Controller: Atocha CRC to the driver of train 2080.
Driver: Yes.
Controller: At 08:36.
Driver: Yes.
Controller: And it reads: driver of train 2080. Switch the LZB off and back on. Resume running. Then resume running under BSL cover, normal running.
Driver: Normal running?
Controller: Yes.
08:41: First call from the Iryo driver
Driver: Good morning, Atocha. I’ve had a loss of transmission running on BSL. The next one has to go at the 113 at over 200. But I haven’t picked up transmission. I’m stopped. At the entrance to Urda.
[Several confused exchanges follow before the controller issues the order.]
Controller: OK, just a moment. This reads: driver of train 6076. Switch off. And switch back on.
Driver: And switch back on.
Controller: Resume running, under BSL cover, normal running.
08:48: Second call from the Iryo driver
Driver: The train isn’t letting me reset the LZB system. That’s why I’m still stopped at the entry signal.
Controller: OK. Understood? Well then, as soon as you can. And if you have a problem, call us back.
Driver: OK, perfect. I’ll get back to you.
Internal conversation at the control centre
Seriously, man. Seriously. The 6071 is having problems with its equipment. It’s moving forward until it stops. It had a Meta40 to continue on BSL. We haven’t changed. Hang on.
[The collision occured a few minutes later]
Click here to read more Spain News from The Olive Press.




